![](/images/new-backgrounds/1179624/1796247x1.webp)
MAZDA 929 1988-91
MAZDA Miata 1990-99
1
2
1
2
"A" |
"A" |
"A" |
"A" |
"A" |
"A" |
"A"
"A"
"A"
"A"
"A"
"A"
Disconnect the negative battery terminal to | Cut and remove all mounting tabs on Radio |
prevent an accidental short circuit. Reach | Housing #1 EXCEPT tabs "A". The |
behind the console and remove (2) nuts | mounting tabs can be identified by the |
supporting the head unit carrier. Remove | stamped letter on the back of each tab. Skip |
the factory head unit and disconnect the | to the Installation Instructions for ALL |
wiring.. | VEHICLES on Page #5. |
MAZDA B-Series Pickup 1986-93
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)screws from the center console storage compartment. Remove (1) screw under the ashtray. Remove (1) screw from each side of the center console panel and remove the panel. Remove (1) screw exposed at the base of the dash trim bezel. Pop out the a/c vents and remove (2) screws exposed. Remove the dash trim bezel.
Cut and remove all mounting tabs on Radio Housing #1 EXCEPT tabs "A". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.
1 |
|
|
| 2 |
|
"C"
"C"
MAZDA MPV 1989-95
1 |
|
|
| 2 |
|
"E"
"E"
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)screws from each side of the radio trim bezel. Remove the ashtray and (1) screw from the rear support tab. Remove the radio trim
(4)screws securing the
3
Cut and remove all mounting tabs on Radio Housing #1 EXCEPT tabs "C". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the ashtray and (2) screws exposed in the ashtray cavity. Remove the radio trim bezel and disconnect the wiring. Remove (4) screws securing the factory head unit and disconnect the wiring.
Cut and remove all mounting tabs on Radio Housing #2 EXCEPT tabs "E". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.
4