MITSUBISHI OUTLANDER 2007-2010
5Remove (7) Phillips screws securing the hazard switch assembly to the back of the factory radio trim panel. Unplug the ribbon cable from the hazard switch assembly and remove assembly from panel from rear. (Retain the screws and switch assembly to be reused during kit preparation) (Figure D,E)
6Remove the labels from the front of the radio trim panel at each side of the hazard switch by pushing them out from behind the panel. (Retain the labels to be reused during kit prepa- ration) (Figure F)
D |
REMOVE |
“9” PHILLIPS SCREWS |
(RETAIN SCREWS) |
E
Continued to kit preparation.
F
2