FINAL ASSEMBLY
A
(A) Strip wire ends back 1/2"
B | B) Twist ends together |
| |
| C) Solder |
C | D) Tape |
| |
D |
|
1Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.)
2
3Reassemble radio and dash assemblies in reverse order of disassembly.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE |
|
| ||
12V | Ignition / Acc | Red | Right Front (+) | Gray |
12V | Batt / Memory | Yellow | Right Front | Gray/ Black |
Ground | Black* | Left Front (+) | White | |
Power Antenna | Blue | Left Front | White / Black | |
Amp | Blue / White | Right Rear (+) | Violet | |
Amp Ground | Black / White | Right Rear | Violet / Black | |
Illumination | Orange | Left Rear (+) | Green | |
Dimmer | Orange / White | Left Rear | Green / Black | |
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
REV. 06/02/09 © COPYRIGHT