Onkyo CR-505DAB instruction manual Using the Radio, Listening to the Radio, Tuning the Radio

Using the Radio

VOLUME

MIN MAX

STANDBY / ON PHONES INPUT MENU DIRECT BASS TREBLE PRESET

PUSH TO ENTER

INPUT

MENU /

STANDBY/ON CLOCK

CALL

2 3

1TIMER

		5	6
		4
		8	9
		7
		--/---	CLEAR		ENTER
		10/0		ENTER
		DISPLAY	MODE		MODE
		SLEEP		REPEAT
INPUT	/	MUTING		INPUT
TUNING	/				PRESET /
	FM	DAB FM	AM	DIRECT	AM
		CD
		MD
		TAPE

Listening to the Radio

1 Press the [AM] or [FM] button to select AM or FM. Or use the [INPUT] button, or the remote controller’s INPUT []/[ ] buttons to select AM or FM.

Tuning the Radio

1 Press and hold the TUNING [] or [ ] button on the remote controller for more than one second and then release it.

The CR-505DAB searches for the next station. Search- ing stops when a station is found.

2 Use the TUNING []/[ ] buttons for fine tuning.

Note:

You can tune the radio with the remote controller only.

If you select the FM band:
When you’re tuned into a station, the Tuned	and “ST’
(FM stereo) indicators appear.
The FM band is searched in 0.05 MHz intervals.
If you select the AM band:
When you’re tuned into a station, the Tuned	indicator
appears.
The AM band is searched in 9 kHz intervals.

■Tuning into weak FM stations

If a station has poor signal strength, you may not be able to tune into that station properly, or reception may be noisy. In this case, switch the FM Mode to Mono, then tune the band.

Switching the FM Mode to Mono:

1 Press the [MODE] button.

2 Use the [ ]/[ ] buttons to display “FM Mode” and press [ENTER].

3 Use [ ]/[ ] to display “Mono” and press [ENTER].

The “ST” (FM stereo) indicator goes off and mono mode is selected.

Using the buttons on the CR-505DAB:

1.Press the [MENU] button.

2.Turn the [ / ] control until “FM Mode” appears on the display and push the [ / ] control.

3.Turn the [ / ] control until “Mono” appears on the display and push the [ / ] control.

28