Onkyo CR-515 CR-315 instruction manual Precautions, Power, Installing this Unit

Page 3

Precautions

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal with- out the permission of the copyright holder.

2.AC Fuse—The AC fuse inside the unit is not user- serviceable. If you cannot turn on the unit, contact your Onkyo dealer.

3.Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the unit immediately afterwards with a clean cloth. Don’t use abrasive cloths, thinners, alco- hol, or other chemical solvents, because they may damage the finish or remove the panel lettering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SEC- TION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable (easily accessible) at all times.

Pressing the [STANDBY/ON] button to select Standby mode does not fully shutdown the unit. If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.

5.Never Touch this Unit with Wet Hands—Never handle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer.

6.Handling Notes

•If you need to transport this unit, use the original packaging to pack it how it was when you origi- nally bought it.

•Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the case.

•This unit’s top and rear panels may get warm after prolonged use. This is normal.

•If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure to use it occasionally.

•When you’ve finished using this unit, remove all discs and turn off the power.

7.Installing this Unit

•Install this unit in a well-ventilated location.

•Ensure that there’s adequate ventilation all around this unit, especially if it’s installed in an audio rack. If the ventilation is inadequate, the unit may overheat, leading to malfunction.

•Do not expose this unit to direct sunlight or heat sources, because its internal temperature may rise, shortening the life of the optical pickup.

•Avoid damp and dusty places, and places subject to vibrations from loudspeakers. Never put the unit on top of, or directly above a loudspeaker.

•Install this unit horizontally. Never use it on its side or on a sloping surface, because it may cause a malfunction.

•If you install this unit near a TV, radio, or VCR, the picture and sound quality may be affected. If this occurs, move this unit away from the TV, radio, or VCR.

8.To Obtain a Clear Picture—This unit is a high- tech, precision device. If the lens on the optical pickup, or the disc drive mechanism becomes dirty or worn, the picture quality may be affected. To maintain the best picture quality, we recommend regular inspection and maintenance (cleaning or worn part replacement) every 1,000 hours of use depending on the operating environment. Contact your Onkyo dealer for details.

9.Moisture Condensation

Moisture condensation may damage this unit. Read the following carefully:

Moisture may condense on the lens of the optical pickup, one of the most important parts inside this unit.

•Moisture condensation can occur in the following situations:

–The unit is moved from a cold place to a warm place.

–A heater is turned on, or cold air from an air conditioner is hitting the unit.

–In the summer, when this unit is moved from an air conditioned room to a hot and humid place.

–The unit is used in a humid place.

•Do not use this unit when there’s the possibility of moisture condensation occurring. Doing so may damage your discs and certain parts inside

this unit.

If condensation does occur, remove all discs and leave this unit turned on for two to three hours. By this time, the unit will have warmed up and any con- densation will have evaporated.

For European Models

Declaration of Conformity

We, ONKYO EUROPE ELECTRONICS GmbH

LIEGNITZERSTRASSE 6, 82194 GROEBENZELL, GERMANY

declare in own responsibility, that the ONKYO product described in this instruction manual is in compliance with the corresponding technical standards such as EN60065, EN55013, EN55020 and EN61000-3-2, -3-3.

GROEBENZELL, GERMANY

K. MIYAGI

ONKYO EUROPE ELECTRONICS GmbH

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents CR-515 CR-315 Avis Important Safety InstructionsPrecautions PowerInstalling this Unit Precautions Supplied AccessoriesBefore Using the CD Receiver Installing the BatteriesUsing the Remote Controller Tuner & Other FeaturesAmplifier CD PlayerContents Getting to Know the CD Receiver Front PanelCR-515 CR-315 Getting to Know the CD Receiver Display Rear Panel Remote Controller RC-662SRC-660S Sleep button Timer button 26, 47, 48, 50Volume / buttons 27 STANDBY/ON button 27Supported Discs Disc NotesMP3 Disc NotesAttach the FM antenna, as shown North American Model Connecting AntennasConnecting the Indoor FM Antenna Connecting the AM Loop AntennaUsing a TV/FM Antenna Splitter Connecting AntennasConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaPush-type terminals Connecting SpeakersConnecting Your Speakers Terminal postsCables and Jacks Connecting Other ComponentsConnecting a Subwoofer About ConnectionsConnecting Other Components Connecting an Onkyo Cassette DeckWhat can you do with CR-515’s Onkyo MD recorder’s Rear panel Connecting an Onkyo MD recorderCR-515’s Rear panel Connecting a Portable Audio Device Connecting an Onkyo CD Recorder CR-515What can you do with ? Connecting an Onkyo Component with a Digital Audio OutputConnecting the Power Cord Connecting a TVHint Turning Off the AccuClock Function First Time Setup European Model OnlyTurning On the CD Receiver Adjusting the VolumeUsing Headphones Basic OperationBasic Operation Adjusting the Bass and TrebleUsing the Super Bass Function Using the Direct FunctionInput Source Name Abbreviations Changing the Input DisplayPlaying CDs Selecting Tracks CR-515Selecting Tracks CR-315 Displaying CD Information Playing CDsSelecting MP3 Files in Navigation Mode Selecting MP3 Files in All Folder Mode Playing the MP3 Files in Only One Folder Memory Playback Press the YES/MODE/SHUFFLE DOM indicator appearsRandom Playback Repeat PlaybackPreferences Folder Key? All Folder/Navigation Hide Number? Disable/EnableListening to the Radio Tuning into Radio StationsAdjusting the Antennas Tuning into weak stereo FM stationsPresetting FM Stations Automatically Auto Preset After Storing Presets You CanListening to the Radio Presetting AM/FM Stations Manually Buttons to select AM or FM Selecting Preset StationsPreset Use the Band or InputWhat is RDS? Displaying Radio InformationReceiving RDS Available Characters Naming PresetsCopying Presets Erasing Presets Erasing a Preset’s NameSetting the Clock Displaying the Time in Standby Mode Setting the ClockSetting the Clock Manually Using the 12- or 24-hour FormatAbout the Timers Using the TimersYou must set the clock before you can program Using the TimersProgramming the Timers Edly to select timer 1, 2, 3, or 4, and then press EnterPress the STANDBY/ON button to If you selected Once, use the PreIf you selected Every, use the Pre If you selected Days Set, usePress Enter repeatedly to see Turning Timers On and OffChecking Timer Settings All of the timer’s settingsUsing the Sleep Timer Canceling the Sleep TimerChecking the Remaining Sleep Time CD Playback TroubleshootingPower AudioExternal Components TroubleshootingRemote Controller TunerTimers Tuner Section SpecificationsGeneral Amplifier SectionMemo Memo 3 4 4 2 5 8 a
Top Page Image Contents