Power Mode Switch, Outputs, Main Power Switch

STA-800D/1000D Equipped Subs

SVSound™

Connectivity & Panel Operations

Power Mode Switch

The Power Mode switch allows the STA-800D/STA-1000D to either stay on all the time, or go into Standby if no signal is being received. When in Standby mode and a signal is detected on one of the inputs, the STA- 800D/STA-1000D will turn on and begin playing the material on its active input(s).

Outputs

There are two types of physical output connectors on the STA-800D/STA1000D; Balanced XLR and single- ended with RCA connectors (also referred to as low level or line level). There are outputs for Left and Right main channels for both types of connectors.

The output connectors are typically used to either daisy-chain additional subwoofers with single or dual unfiltered outputs, or as the input to a power amplifier for the Left and Right main channels after using the High Pass Filter and (optionally) Delay functions with two channel analog preamps (see discussion above under “Inputs”).

Main Power Switch

Use this switch to apply power to the STA-800D/STA-1000D amplifier.

Power Cord

Plug the power cord into a wall outlet. Do not use extension cords to lengthen the cord. Do not plug into accessory outlets on the back of an AVR or pre/pro.