Operation of the Power Mode Switch

STA-800D/1000D Equipped Subs

SVSound™

Connectivity & Panel Operations

NOTE: Depending on the version of the STA-800D/STA-1000D amplifier, the LCD display may or may not light when power is first applied. Even if the LCD display does not light when power is applied, if the amplifier is in the AUTO mode, it will play source material when a suitable signal is applied.

To manually come out of Standby when in AUTO mode, press and hold the IFC knob for several seconds until the display lights. Note that menu operations are not possible when the amplifier is in Standby.

In AUTO mode If power is removed from the amplifier either through the main power rocker switch, or by loss of power from the mains (wall outlet) and then restored, the amplifier will either turn back on or come up in Standby. If it comes up in the on state, it will revert to Standby after a period of time if no signal is presented at the inputs.

When the AUTO/ON Switch is in the ON position and power is applied to the amplifier via the main power switch, the amplifier will NOT turn on. In order to turn the amplifier on, the IFC knob must be pressed and held in for several seconds. When the amplifier turns on, the LCD display will illuminate at the WELCOME screen for a few seconds. The amplifier will stay on until either the IFC knob is pressed and held until the LCD display goes dark, when power is removed from the amplifier using the main power switch, or power is removed from the mains (wall outlet).

If power is removed from the amplifier either through the main power switch or by loss of power from the mains (wall outlet) and then restored, the amplifier will not turn back on until the IFC knob is pressed and held as noted above.

It is important to note in case of a power outage, it will be necessary to manually turn the amplifier on by pressing and holding the IFC knob as noted above. STA-800D and STA-1000D Connectivity and Panel Operation.