Sharp LC-50LE651E/K/V Setting options for DVB-C reception, Setting options for DVB-S reception

Quick guide

8Supplying power to the antenna.

If you use a DVB-T antenna that requires a supply voltage and which is not supplied via a power adapter, then select yes (5V) for the antenna's power supply.

NOTE

•The value of Frequency and Network ID should be set to the value specified by the cable provider.

Press J to continue.

Press Jbutton.

How to align your DVB-T antenna is described on page 14.

9Continue with Settings for all types of reception (See page 13).

Setting options for DVB-C reception

If you have not selected DVB-C antenna in the antenna selection, continue with Setting options for

DVB-S reception below.

The normal DVB-C settings are derived from the selection of the location and do not need to be changed.

Press ▲/▼/◄/► to change each item to the appropriate settings:

●Network selection

If several networks are available via DVB-C, you can decide which network you want to receive your channels from.

●Scrambled stations

You can specify if coded stations are to be searched for in the search/update.

Select yes to save all scrambled stations.

•These stations can only be received in connection with a CI module and the appropriate CA Card.

•If a CI module with a CA Card is already inserted for the station search, all the stations which this module can descramble are also saved when no is selected.

●Search method

If you select Frequency Search, a search is performed for all receivable stations. With Network Search, only the stations which the networks supply are searched, either for all receivable networks or only for the particular network specified under Network ID.

●Start Frequency

The DVB stations are only searched for in the frequency range above the start frequency.

●Network ID

Change this setting to register only the specified network ID.

●Accept logical channel number

In various countries, digital stations are transmitted with a preset channel number per station, known as "Logical Channel Numbers" (LCN).

If you select yes, these default channel numbers will be used and the channels will be sorted as per LCN.

Setting options for DVB-S reception

If you have not selected a DVB-S antenna in the antenna selection, continue with Settings for all types

of reception on page 13.

Select the satellite system.

Specify how you receive which satellite(s) (single satellite or type of satellite system). Ask your dealer in this regard.

The normal DVB-S settings are derived from the selection of the location and do not need to be changed in most cases.

●Single satellite

Reception of a single satellite via a connected LNC (LNB). See page 11 for settings.

●2 satellites on 22kHz switchbox

Reception of two different satellites with two LNCs (LNBs) which are connected to the TV set by a 22 kHz switchbox. See page 11 for settings.

●2 satellites on Toneburst switch

Reception of two different satellites with two LNCs (LNBs) which are connected to the TV set by a toneburst switch. See page 11 for settings.

●Max. 4 satellites on DiSEqC multiswitch

The TV set controls a DiSEqC multiswitch to which up to four LNCs (LNBs) for different satellites are connected. See page 11 for settings.

●DiSEqC one cable communal system

Select setting if the TV set is connected to a DiSEqC single cable system (according to EN50494). Several satellite receivers can be connected to one satellite cable. See page 12 for settings.

●Other communal installation

Select this setting if the TV set is connected to a single-cable system (without DiSEqC). Several satellite receivers can be connected to one satellite cable. As opposed to a DiSEqC one cable system there are restrictions in the range of certain reception frequencies in common single-cable community systems. See page 13 for settings.

Press J to continue.

10