Alphasonik PBAT10E owner manual Mounting

Page 6

C

 

 

H

 

 

O

 

It is always best to plan the complete installation prior to attempt-

O

 

ing to install any product. The routing of wires, power connections and

S

mounting locations should be planned first. As with any car stereo instal-

I

N

lation, all work performed should be checked thoroughly and carefully

G

prior to the operation of the system.

A

 

The placement of your Alphasonik enclosure within your vehicle

L

 

will greatly affect the overall performance of your audio system. Avoid

O

areas that do not provide a flat, sturdy mounting surface.

C

 

 

A

NOTE:

Alphasonik strongly recommends that you operate your system at

T

I

low volumes prior to the completed installation of your Alphasonik enclo-

O

sure. This will allow a test of the speaker before securing it to its perma-

N

nent location.

 

CAUTION: Make sure that all wiring is fully protected from cuts, tears

 

and possible wear. Any short circuit developing as a result could severely

 

damage the source unit or possibly the amplifier. Make sure all wires eas-

 

ily reach the amplifiers terminal with no stress on the wires or connectors.

 

 

MOUNTING:

 

1.

Confirm the mounting location by inspecting the area where the

 

 

enclosure will be mounted.

 

2.

Before screwing anything double check where all wires are located

 

 

and ran. Check underneith the vehicle for gas lines, brake lines,

and gas tank. If there is anything like that we suggest to find an other location to mount the enclosure.

5

Image 6
Contents Alphasonik R T T I N G T H E P a C E S I N C E 1 9 7 B L E O F C O N T E N T S Thank you for purchasing this Alphasonik product. Al T U R E S Specification S PBAT10E 10 Amplified Vented Bass EnclosureMounting A L L a T I O N A L L a T I O N C O E DTroubleshooting No SoundDisclaimer R a N T Y Dated Proof of Purchase is Required for WARInstalled Warranty T E S T E S T E S Alphasonik INC Village DR. BLDG. G Buena PARK, CA