LG Electronics owner manual Mounting on a wall, IPS225P/IPS235P

Page 10

10ASSEMBLING AND PREPARING

ENGLISH

Mounting on a wall

For proper ventilation, allow a clearance of 10 cm on each side and from the wall. Detailed instructions are available from your dealer, see the optional Tilt Wall Mounting Bracket Installation and Setup Guide.

10 cm

10 cm

10 cm

10 cm

Model

IPS225P/IPS235P

VESA (A x B)

100 x 100

Standard screw

M4

Number of screws

4

VESA (A x B)

B A

If you intend to mount the Monitor set to a wall, attach Wall mounting interface (optional parts) to the back of the set.

When you install the Monitor set using a wall mounting interface (optional parts), attach it carefully so it will not drop.

1Please, Use the screw and wall mount interface in accordance with VESA Standards.

2If you use screw longer than standard, the monitor might be damaged internally.

3If you use improper screw, the product might be damaged and drop from mounted position. In this case, LG Electronics is not responsible for it.

4VESA compatible.

5Please use VESA standard as below.

yy784.8 mm (30.9 inch) and under

*Wall Mount Pad Thickness : 2.6 mm

* Screw : Φ 4.0 mm x Pitch 0.7 mm x

Length 10 mm

yy787.4 mm (31.0 inch) and above

*Please use VESA standard wall mount pad and screws.

CAUTION

yyDisconnect the power cord first, and then move or install the Monitor set. Otherwise electric shock may occur.

yyIf you install the Monitor set on a ceiling or slanted wall, it may fall and result in severe injury.

yyUse only an authorized LG wall mount and contact the local dealer or qualified personnel.

yyDo not over tighten the screws as this may cause damage to the Monitor set and void your warranty.

yyUse only screws and wall mounts that meet the VESA standard. Any damages or injuries by misuse or using an improper accessory are not covered by the warranty.

NOTE

yyUse the screws that are listed on the VESA standard screw specifications.

yyThe wall mount kit will include an installation manual and necessary parts.

yyThe wall mount bracket is optional. You can obtain additional accessories from your local dealer.

yyThe length of screws may differ depending on the wall mount. Be sure to use the proper length.

yyFor more information, refer to the instructions supplied with the wall mount.

Image 10
Contents LCD Monitor Contents Unpacking Stand Base Power Cord DVI-D CableAssembling and Preparing Card SUB CablePower Button Button See p.13 Connection panel See p.11 Parts and buttonsOSD Locked UnlockedDetaching the Stand Base Setting up the Monitor setAttaching the Stand Base Stand BaseMounting on a table Ergonomic Using the Pivot function Mounting on a wall IPS225P/IPS235PDVI-D connection Using the Monitor SETConnecting to a PC SUB connectionYySelf Image Setting Function Yy‘AUTO’ FunctionMonitor set Buttons Customizing SettingsAccessing The Main Menus ExitCustomizing Settings Menu SettingsPicture SharpnessGreen Color Temp PresetUser BlueVertical Monitor Setup OSD menuPhase ClockReset PowerIndicator WhiteText Mode SettingMovie PhotoDual Monitor OFF Dual Package SettingAvailable picture settings are described below Dual WEBTroubleshooting Check the following before calling for serviceSettings 1080PSpecifications ‌SPECIFICATIONS IPS235PPreset Modes Resolution IndicatorPage Model Serial