Wiring Diagram
IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have the installation handled by an experienced technician.
Need Help? For technical assistance, call the Jensen customer support line at
Antenna
15 Amp Fuse | 15A |
What’s in the Box | Tools and Supplies | ||
• | BT1613 Head Unit | You will need these tools and supplies to install your | |
• | Cosmetic Trim Ring | BT1613: | |
• | Wiring Harness Power/Speaker | • Torx type, | |
• | Mounting Hardware | • Wire cutters and strippers | |
• | Remote Control | • Tools to remove existing radio (screwdriver, | |
• | jLink iPod Cable |
| socket wrench set or other tools) |
• | 3.5mm Media Cable | • | Electrical tape |
• | Owners Manual | • | Crimping tool |
• | Installation Guide | • | Volt meter/test light |
|
| • | Crimp connections |
|
| • 18 gauge wire for power connections | |
|
| • 16 – 18 gauge speaker wire |
NOTE: When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. This head unit uses one 15 amp fuse located below the wiring connector (15 amp fast blow ATO).
Grey
RCA Outputs to Amplifier
Left Front Speaker
White/Black
Subwoofer
Output
Dark Blue
Black
Yellow
+
Red
Grey/Black
iPod/jLink connector
Use this
Power Antenna (dark blue wire) Connect to the power antenna or an amplifier. If not used, tape the bare end of wire.
Ground (black wire)
Connect to the ground terminal or a clean, unpainted part of the chassis.
Memory/Battery (yellow wire) Connect to the battery or to a 12 volt power source that is always live. The radio will not work if this wire is not connected.
Accessory/Ignition (red wire)
Connect to the existing radio wire or radio fuse.
iPod
WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions.
SERIES
BT1613
Installation Guide
White (+)
Right Front Speaker
Left Rear Speaker
Grey (+)
jLink
iPod Cable
BT1613 |
Green/Black
Green (+)
Violet/Black
Right Rear Speaker
Violet (+)
PS/AS |