! IMPORTANT
When bridged, the amplifier
will deliver 360W x 1 into a 4 ohm load or 220W x 1 into an 8 ohm load. Operating a pair of bridged channels into a load lower than 4 ohms is not recommended.
Because a bridged pair of channels requires that both channels receive input, you need to connect both left and right inputs to the source unit. Connection of only one input will result in reduced power output, increased distortion and can cause the amplifier to overheat.
Do not do this!
When the
1)Left Channel Only or Right Channel Only Information: If you wish to send a
J2-360.2 to drive right channel speakers only.
2)Left + Right Channel Information: When bridged and fed by a stereo input, the
(left + right) channel. This option is useful when using a the
AMPLIFIER Status Indicator Lights & Protection Circuitry
There are two status indicator lights on the control panel of the amplifier.
Power | Protect |
+9dB ass Boost
1)“Power” (Green): lights to indicate that the amplifier is turned on and operating normally. Located at the far left of the control panel.
2)“Protect” (Red): Indicates that the amplifier protection circuitry has been activated
to prevent product failure due to thermal overload,
Servicing your Amplifier
If your amplifier fails or malfunctions, please return it to your authorized JL Audio dealer so that it may be sent in to JL Audio for service. There are no user serviceable parts or fuses inside the amplifier. The unique nature of the circuitry in the JL Audio amplifiers requires specifically trained service personnel. Do not attempt
to service the amplifier yourself or through unauthorized repair facilities. This will not only void the warranty, but may result in the creation of more problems within the amplifier.
If you have any questions about the installation or setup of the amplifier not covered in this manual, please contact your dealer or technical support.
JL Audio Technical Support:
(954)
9:00 AM – 5:30 PM (Eastern Time Zone)
Monday - Friday
10 | JL Audio | 11 |