Jensen owner manual Specifications, XA2150 Amplifier

Page 12

Specifications

XA2150 Amplifier

Power output @ 14.4 VDC, 20-20 kHz

............ (4 ohms) 75 Watts per channel RMS, < 00.08% THD

 

(2 ohms) 100 Watts per channel RMS, < 00.1% THD

 

(4 ohms) bridged 200 Watts per channel RMS, < 00.1% THD

Frequency Response

20 Hz-20 kHz ± 3 dB

Signal to Noise Ratio @ Rated Power

>100 dB

Channel Separation @ Ref. Power

>65 dB, 1 kHz

THD & IMD @ Ref. Power into 2 ohms

..................................................................................... <0.1%

Speaker Impedance

2-8 ohms

Input Impedance

20 k ohms

Crossover Frequencies

Low/High: 50-250 Hz

Power Requirement

14.4 VDC (10.8-15.6 VDC allowable)

Fuse Requirements

30 amp blade-type fuse

Dimensions

2.25" x 11.125" x 8" (56.5mm x 282mm x 203mm)

Specificationssubjecttochangewithoutnotice.

Limited One Year Warranty–USA and Canada

Length of Warranty. This warranty from Recoton Mobile Electronics shall be in effect for a period of one year from the date of the first consumer purchase.

Persons Protected. This warranty will be enforceable by the original owner and any subsequent owners during the warranty period so long as proof of date of purchase from an authorized Jensen dealer is presented whenever warranty service is required.

What is Covered. Except as otherwise specified below, this warranty covers all defects in material and workman- ship in this product. The following are not covered: damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product; damage occurring during shipment (claims must be presented to the carrier); elimination of car static or other electrical interferences; any product purchased outside USA or Canada, or on which the serial number has been defaced, modified or removed.

How You Can Get Service.

U.S. Purchasers. Please telephone Jensen at

1-800-323-4815. We will either inform you of the name and address of an authorized Jensen repair station which will service the product or will advise you to send the product to a factory service center.

Canadian Purchasers. The product should be returned to the Jensen dealer from whom it was purchased and such dealer either will service or arrange for service of the product.

If shipment of the product is required, it should be packed securely. The original dated bill of sale must always be included with the product as proof of warranty coverage.

What We Will Pay For. We will pay for all labor and material expenses required to repair the product, but you must pay any labor costs for the removal and/or installation of the product. If the product is shipped for warranty service, you must prepay the initial shipping charges, but Jensen will pay the return shipping charges if the product is returned to an address inside the USA or Canada.

Limitation of Implied or Statutory Warranties and

Conditions. All implied or statutory warranties and conditions, including warranties or conditions of merchant- ability, fitness for particular purposes and non-infringement, are limited in duration to the length of this warranty.

Exclusion of Certain Damages. Jensen’s liability is limited to the repair or replacement, at our option, of any defective product and shall not include incidental or consequential economic damages of any kind.

Some states and/or provinces do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations and exclusions may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state and province to province.

®

Recoton Mobile Electronics

A Division of Recoton Audio Corporation

ARECOTON® COMPANY 1090 Emma Oaks Trail

Lake Mary, Florida 32746

©1998 Recoton Audio Corporation

Image 12
Contents How to Install and Operate the XA2150 Amplifier ContentsTechnical Assistance Installation Before You Begin InstallationAmplifier Location Disconnect Battery Amplifier Installation KitRouting Wires Supplies and Tools NeededSupplies ToolsWiring Power Terminal Batt +12VRemote Terminal RMT +12V Ground Terminal GNDInput Wiring Power LightPass Output Protect LightCrossover X-OVER Input Level ControlBass Boost Speaker Wiring Speakers SubwoofersSpeakers + Subwoofer Bridged SubwooferTesting Reconnect BatteryTest Power Wiring Test Speaker ConnectionsInstalling in Trunk Securing WiresSpeaker and Power Wires Crimp ConnectionsTroubleshooting Problem Possible Cause Corrective ActionSpecifications XA2150 Amplifier