JL Audio SB-B-5SER/12W6v2 warranty Estimated Time Hour, E P, Step

SB-B-5SER/12W6v2_INSTR_SKU#011233

I N S T A L L A T I O N G U I D E

for the

SB-B-5SER/12W6v2

2004 - Up 5 Series

If you choose to perform the installation yourself, it is absolutely vital that the Stealthbox® be properly mounted to the vehicle according to these instructions. Failure to mount the enclosure properly presents two problems:

1)The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).

2)A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

INSTALLATION D I F F I C U LT Y :

1OUT

5OF

ESTIMATED TIME:

1 HOUR

Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper

installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio dealer. The installation professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you prefer to perform your own installation, please read this installation guide completely

before beginning the process.

Side Clip

Rear Clip

S T E P 1

Remove all contents from the trunk.

Remove the two plastic clips from the driver’s side of the trunk, that are indicated by the arrows in the picture.

Remove this side panel from the trunk.

S T E P 2

Place the supplied weld nut into the same mounting hole as the side position factory clip that was removed

in STEP 1.

Mark the three holes from the flange of the weld nut onto the factory metal pane. Remove the weld nut.

With a 1/8-inch drill bit and drill. Drill out the metal panel at the marked locations. You are close the outside sheet metal, use care when drilling through the metal.

Secure the threaded insert with the three supplied rivets.

S T E P 3

Run speaker wire from the amplifier location to the Stealthbox® location.

Continued on Next Page