JL Audio SB-B-5SER/12W6v2 warranty Place the side panel back into the trunk, E P 1

S T E P 4

Place the side panel back into the trunk.

S T E P 5

Place the rear factory clip back into place.

Thread the supplied set screw stud into the weld nut, leave 1 1/2-inch exposed.

S T E P 6

Place the supplied spacer onto the set screw stud.

S T E P 7

Remove the 9 o’clock and 3 o’clock position mounting screws from the woofer. Replace these mounting screws with the supplied threaded rods.

Remove all the mounting screws, woofer and fill from the Stealthbox®.

SB-B-5SER/12W6v2_INSTR_SKU#011233

S T E P 8

Attach the speaker wire to the terminal on the Stealthbox®.

S T E P 9

Position the Stealthbox into position.

Carefully guide the threaded stud through the hole on the back side of the Stealthbox®.

S T E P 1 0

From inside the Stealthbox®, place the supplied washer, lock wash and then nut onto the set screw stud.

Using a 9/16-inch deep socket, secure tightly.

Do not over tighten.

S T E P 1 1

Place the fill back into the Stealthbox®.

Page 2 • JL Audio, Inc 2007 Continued on Next Page