Clark Synthesis TA0.1 owner manual Initial Settings Prior to Making Connections

SETTING UP YOUR AMPLIFIER

Initial Settings Prior to Making Connections

!CAUTION: Before connecting any wires or input/output lines, insure all equipment is off and no signals are being sent from the input device.

In order to reduce the chances of accidentally damaging the amplifier or transducer, please set the amplifier controls to the safety positions described and shown below:

•Set the On/Auto/Off Switch to the “Off” position (see photo #1)

•Set the Gain (Volume) Control to “Min” (completely counter-clockwise, see photo #2)

•Set the Input Signal Switch on the back of the amplifier to the “High” position (see photo #3)

Photo #1	Photo #3
Photo #2

www.clarksynthesis.com TA0.1 Amplifier 15