LOCK WASHER
FLAT WASHER | THREADED INSERT |
STEALTHBOX®
MOUNTING BRACKET |
LOCK WASHER |
HEX BOLT |
VEHICLE BODY
RIVET NUT
PHILLIPS HEAD SCREW
S T E P 1 2
Attach the upper mounting bracket into the just installed
S T E P 1 3
The two lower brackets from the Stealthbox® should be con- figured as shown, the one that goes up will be the same, just arranged vertically.
S T E P 1 6
Test the Stealthbox® to ensure proper operation then, remount using the supplied three Phillips Head Screws, Split Lock Washers and, Flat Washers.
S T E P 1 7
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier recommendation and basic
S T E P 1 4
Press in at the bottom of the enclosure so that it sits as tight in the side as possible, and mark the locations for the bottom anchors to be drilled through the floor. Remove the enclo- sure from the side.
S T E P 1 5
Using a drill with a 3/8” bit, drill through the locations marked in STEP 14 . Repeat STEP 10 in both holes.
*CAUTION*
Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, exhaust systems or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling.
Page 3 • JL Audio, Inc 2008 | Continued on Next Page |