S T E P 1 9
Position the Stealthbox® in the mounting location.
S T E P 2 0
The front of the Stealthbox® fits against the black plastic panel located on the passenger side.
S T E P 2 1 A
The rear of the Stealthbox® is to be fitted between a pair of tabs that are protruding up from the flooring.
This is the driver’s side tab.
S T E P 2 1 B
This is the passenger’s side tab.
S T E P 2 2
Once the Stealthbox® is in the mounting location, press down on it firmly.
Remove the Stealthbox® carefully, leaving the wax squares in place. The socket cup set screws will leave impressions in the wax.
S T E P 2 3
Note: Before drilling, make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, transfer case (4x4 vehicles)
or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling!
With a drill and a
Remove the wax squares and the tape.
S T E P 2 4
Run speaker wire from the amplifier’s location to the Stealthbox® location and check for proper operation of the woofer.
Back out the socket cup set screws installed in Step 18, to expose 1
S T E P 2 5
Place the Stealthbox® into position by guiding the socket cup set screws through the holes drilled in Step 23.
Page 4 • JL Audio, Inc 2006 | Continued on Next Page |