Lanzar Car Audio SDBT75NU owner manual Installation Opening, Installing the unit

Page 6

INSTALLATION

Notes:

Choose the mounting location where the unit will not interfere with the normal driving function of the driver.

Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.

Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.

Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.

If installation angle exceeds 30˚ from horizontal, the unit might not give its optimum performance.

30˚

Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration.

DIN FRONT/REAR-MOUNT

This unit can be properly installed either from “Front” (conventional DIN Front- mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis).

For details, refer to the following illustrated installation methods.

DIN FRONT-MOUNT (Method A)

Installation Opening

This unit can be installed in any dashboard having an opening as show below:

53 mm

182 mm

Installing the unit

Be sure you test all connections first, and then follow these steps to install the unit.

1.Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.

2.Disconnect the wire harness and the antenna.

3.Lift the top of the outer trim ring then pull it out to remove it.

4.The two supplied keys release tabs inside the unit's sleeve so you can remove it. Insert the keys as far as they will go (with the notches facing up) into the appropriate slots at the middle left and right sides of the unit. Then slide the sleeve off the back of the unit.

Sleeve

L Key

Outer Trim Ring

R Key

5.Mount the sleeve by inserting the sleeve into the opening of the dashboard and bend open the tabs located around the sleeve with a screwdriver. Not all tabs will be able to make contact, so examine which ones will be most effective. Bending open the appropriate tabs behind the dashboard to secure the sleeve in place.

6

Image 6
Contents SDBT75NU Features USE this Product SafelyContents Safety Information Region Management Information Region Management InformationDisc Notes DVDMP3 Installation Installation OpeningInstalling the unit Removing the unit DIN REAR-MOUNT Method B Closed Position PlayerFront View Open PositionInch TFT Touch Screen Monitor Remote Sensor Connector Black Electrical ConnectionRemote Control Location and Function of KeysANG Preparing the Remote Control LOAD/EJECT a DiscTurning the player on/off OperationBasic Operation Open/Close the MonitorReset Mode SelectionVolume Level Adjustment SetupAudio SystemDVD Setup Default Smart Mode OperationMute and Brake Function Skipping Track Pausing Play/Step PlaySlow Motion Playback For DVD Only DVD Video Menu PlayRepeat A-B ON-SCREEN Display FunctionRepeat a CancleSpecial Functions for DVD Multi-subtitle Language Function Goto FunctionZoom Function Program PlaySystem Setup DVD SetupThere are two method to enter the DVD Setup menu Language SetupAudio Setup Frequently Asked QuestionsD I O O U T KEY I T S E T U P Radio Operation Switching to AV mode AV OperationUSB Play Operation Trouble Shooting Specifications RadioDVD
Related manuals
Manual 29 pages 1.22 Kb