Removing the unit

INSTALLATION

Dashboard

Tabs

Screwdriver

Sleeve

6.Reconnect the wire harness and the antenna and be careful not to pinch any wires or cables.

7.Slide the unit into the sleeve until it locks into place.

8.To further secure the unit, use the supplied metal strap to secure the back of the unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring Washer) to attach one end of the strap to the mounting bolt on the back of the unit. If necessary, bend the metal strap to fit your vehicle's mounting area. Then use the supplied hardware (Tapping Screw (5x25mm) and Plain Washer) to attach the other end of metal strap to a solid metal part of the vehicle under the dashboard. This strap also helps ensure proper electrical grounding of the unit.

Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard.

9.Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front panel. (see the steps of “using the detachable front panel”).

1.Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.

2.Remove the metal strap attached the back of the unit (if attached).

3.Lift the top of the outer trim ring then pull it out to remove it.

4.Insert both of the supplied keys into the slots at the middle left and right sides of the unit, then pull the unit out of the dashboard.

Spring Washer

Metal Strap

Mounting Bolt

Hex Nut

Plain Washer Tapping Screw