ONX1.1000D / ONX1.1500D
Mono Amplifiers
FEATURES:
-1 Set of RCA inputs
-LEVEL: Variable sensitivity from 0.2V to 6V
-BASS EQ: Adjustable 45Hz bass boost from 0dB to 10dB
-SUBSONIC: Variable from 15Hz to 35Hz
-LOW PASS: Variable from 30Hz to 250Hz
OUTPUT | INPUT | LEVEL | BASS EQ REMOTE SUBSONIC LOW PASS |
L | L |
| POWER |
PROTECT
6V 0.2V 0dB 10dB |
| 15Hz 35Hz 30Hz 250Hz |
RR
-POWER LED: Indicates the powered up and turned on condition
-PROTECTION LED: Indicates a high voltage, low voltage, short circuit, hard clip, over heating or DC fault condition.
-LINE OUTPUT: Full range RCA pass through.
Interconnect cable checklist:
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables.
Use at least #12 gauge speaker wiring. The amps have dual speaker terminals, simplifying the hookup of multiple speakers. These amps are mono, 1 channel, amplifiers which have multiple positive and negative connections for ease of wiring. The 2 positives are the same internally and the 2 negatives are the same internally.
Control checklist:
Refer to the section “Settings for Best Performance”
Minimum final loudspeaker impedance: 1-Ohm.
DESIGNATED
MONO OUTPUT FROM HEAD UNIT
MIN MAXX
R | L | OUTPUT |
R | L | INPUT |
6V 0.2V |
| LEVEL |
0dB 10dB |
| BASS EQ |
|
| REMOTE |
15Hz 35Hz |
| SUBSONIC |
30Hz |
| LOW |
250Hz |
| PASS |
PROTECT | POWER |
|
ONYX
OUTPUT | + | MONO |
+ | ||
SPEAKER | - | SUBWOOFER |
|
| |
| - |
|
FUSE |
|
|
INPUTPOWER | BATT+12VREMGND | TO BATTERY + 12 Volts |
VIA FUSE | ||
|
| REMOTE |
|
| CHASSIS GROUND |
7