Final Installation - Method B
DIN |
|
| |
If your vehicle is a Nissan or Toyota, fol- |
| Side View Showing | |
low these mounting instructions: |
| ||
| Screw Holes Marked | ||
Use the screw holes marked T (Toyota), |
| ||
| T, N | ||
N (Nissan) located on both sides of the |
| ||
|
| ||
unit to fasten the unit to the factory radio | Factory Radio |
| |
mounting brackets supplied with your | Screw | ||
vehicle. | Mounting Bracket |
| |
To fasten the unit to the factory radio |
|
| |
mounting brackets. |
|
| |
1. Use a screwdriver to loosen the hook’s |
|
| |
screws on the front left and right |
|
| |
sides of the unit and remove the |
|
| |
hooks. | Screw |
| |
2. Align the screw holes on the bracket |
| ||
|
| ||
with the screw holes on the unit, and | Hook | Dashboard or Console | |
then tighten the screws (5 x 5mm) on | |||
|
| ||
each side. |
|
| |
Note: The outer trim ring, sleeve and the |
|
| |
metal strap are not used for Method B |
|
| |
installation. |
|
|
Specifications
CD Player
Signal/Noise Ratio . . . . . . . . . . . . . . . . > 86 dB
Frequency Response . . . . . . . . 20 Hz – 20 kHz
Channel Separation . . . . . . . . . . . . . . . > 65 dB
D/A Converter . . . . . . . . . . . . . . . . . . . 1 Bit/CH
FM Tuner
Tuner Range . . . . . . . . . . . . 87.5 – 107.9 MHz FM Mono Sensitivity . . . . . . . . . . . . . . . 12 dBf 50 dB Quieting Sensitivity (Stereo) . . . . 16 dBf Stereo Separation @ 1 kHz . . . . . . . . . . 40 dB
AM Tuner
Tuner Range . . . . . . . . . . . . . . 530 – 1720 kHz
Amplifier
Total System Power . . . . . . . . 160 Watts Peak Power Output . . . . . . . . . . . . . . . . . . . 4 x 40W
General
Power Supply . .
. . . .178 mm (W) x 178 mm (D) x 55 mm (H)
Specifications are subject to change without notice.
11