QS216
We strongly recommend that you have your new Q series speakers installed by your authorized MB Quart dealer. The installation professionals employed by your dealer have the necessary tools and experience to disassemble your vehicle, install your new speakers and reassemble everything properly. If you prefer to perform your own installation, it is very important that you read the entire manual first.
GETTING STARTED:
-Turn off the audio system.
-Check clearance on both sides of mounting surface to ensure that there are no obstructions (windows, tracks, wiring etc).
CROSSOVER NETWORK INSTALLATION:
-Locate a dry location for mounting of your Q Crossover Networks. DO NOT MOUNT IN
DOORS!
-Remove the cover of the crossover by squeezing either side. This exposes the mounting holes for securing the crossover to a flat surface. Prior to
-Once the crossover is mounted, snap the protective cover back in place.
WIRING DIAGRAMS FOR STANDARD WIRING
AND BI-AMP WIRING
Standard Wiring Configuration: This wiring
configuration is used when you want to power
each crossover with a single amplifier channel. It is important that you leave the jumper pins in the locations shown in the diagram labeled Standard.
STANDARD
Crossover #1:
1.Connect Amplifier Channel 1 + to Crossover WF + IN.
2.Connect Amplifier Channel 1 - to Crossover WF - IN.
3.Connect Crossover WF + and - output to the corresponding + and - on midrange speaker #1.
4.Connect the Red tweeter wire to the output TW + on the Crossover.
5.Connect the Black tweeter wire to the output
TW - on the Crossover.
Crossover #2:
1.Connect Amplifier Channel 2 + to Crossover WF + IN.
2.Connect Amplifier Channel 2 - to Crossover WF - IN.
3.Connect Crossover WF + and - output to the corresponding + and - on midrange speaker #2.
4.Connect the Red tweeter wire to the output TW + on the Crossover.
5.Connect the Black tweeter wire to the output
TW - on the Crossover.
Bi-Amp
Crossover #1:
1.Connect Amplifier Channel 1 + to Crossover WF + IN.
2.Connect Amplifier Channel 1 - to Crossover WF - IN.
3.Connect Crossover WF + and - output to the corresponding + and - on midrange speaker #1.
4.Connect Amplifier Channel 3 + to Crossover TW + IN.
5.Connect Amplifier Channel 3 - to Crossover TW - IN.
4.Connect the Red tweeter wire to the output TW + on the Crossover.
5.Connect the Black tweeter wire to the output
TW - on the Crossover.
Crossover #2:
1.Connect Amplifier Channel 2 + to Crossover WF + IN.
2.Connect Amplifier Channel 2 - to Crossover WF - IN.
3.Connect Crossover WF + and - output to the corresponding + and - on midrange speaker #2.
4.Connect Amplifier Channel 4 + to Crossover TW + IN.
5.Connect Amplifier Channel 4 - to Crossover
TW - IN.
4.Connect the Red tweeter wire to the output TW + on the Crossover.
5.Connect the Black tweeter wire to the output TW - on the Crossover.