Bogen M450, BOGEN M300, M600 manual Module Installation

Page 9

Installation

Module Installation

Installation

Two input module bays are available to accept various Bogen input modules thereby allowing users to customize the amplifier to suit the needs of the installation. Read the instructions included with the module and make the desired jumper setting changes before installing the module. The sleep switch should be set to the desired position prior to installation of the right module since it will be covered by the module (see Operation, Sleep Mode Defeat).

The input modules are installed by simply sliding them along the card guides inside the module bays until the faceplate firmly sits against the M-Class chassis, then use the two screws supplied with the module to secure it to the chassis.

Note: The input module included with the amplifier is pre-installed and factory set for 0 dB gain (can also be changed to 18 dB boost) and to be muted by any other module (can also be set to “no mute”).To change those settings, refer to the manual included with the module.

6

Page 8 Page 10
Image 9
Page 8 Page 10
Contents
Class Amplifier M300, M450, & M600 Models Domestic and International Listings Important Safety InformationContents Introduction Package Contents Class Front Panel Panel DescriptionsClass Rear Panel Installation Components InstallationRack Mounting VentilationRear Rack Mounting Table MountingInstallation Module InstallationConnections SpeakersStandard Input Module included Sleep Mode Defeat Controls & ConnectorsOperation Level ControlsModes of Operation Stereo ModeEffects Loop Output Feeds70V Mono Mode Dual Mono ModeAudio Buses Modules Applications Mode of Operation 70V MonoMode of Operation Dual Mono Turn off, then turn back on TroubleshootingTechnical Specifications M600 M450 M300 SpecificationsSpring Street, Ramsey, NJ 07446, U.S.A Tel -934-8500, Fax
Top Page Image Contents