BASIC OPERATION
9.CLK Button
Press it to change the display to clock display. Press it again to return to previous display. In clock display, press and hold for about 2 seconds until the hour display flashes, rotate VOL+/- button to adjust hours . Press it again, the minute display flashes , rotate VOL+/- button to adjust minutes.
10.
/CH 1-6 (RADIO PRESET) a). In Disc Playback Mode
Press this button to pause playback, press it again to resume playback. B). In Radio Mode
Press this button repeatedly to preset station. With this system a total of 30 stations can be stored in the memory . Each band store up to six preset stations. The stations might be FM1, FM2, FM3, AM1 (MW1) and AM2 (Mw2) band.
The operation as below: - store in memory
press and hold the desired memory location for several seconds, the current listening station will be stored into the number location.
- retrieve a preset station
press it button repeatedly to retrieve a station which had been stored in the memory in advance the chosen number is shown on display.
11/12 . / Buttons
(tune, Seek, Track, Skip Up/down)
a) In DISC, USB mode:
if you wish to jump forwards or back-
wards press briefly the or button . (Note: during the DVD playback , press
the button continually twice to skip back one track during playback.) Press and hold up for more than two seconds to begin Fast Forward (or down for Fast Reverse) mode. Press the button again as needed, to cycle thru the range of available speeds.
DVD/VCD/CD/MP3:
Normal Playback 2x 
4x 
8x 
16x
b) In Radio Mode:
Press briefly the or button to manu- ally tune the radio in single steps. Press and hold for two seconds to start the search for a radio station automatically.
13. MOD BUTTON
Press it repeatedly to select AUX IN , RADIO and DISC mode. During the USB playback, you can press STOP button and then press GOTO button to select the DISC mode.
14. 
(EJECT) Button
In DISC playing ,Press the Open button
(1)to flip down the front panel, then you can press the this button to eject the disc .
15. RESET Button
RESET button is placed on the housing and must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons:
A. Initial installation of the unit when all wiring is completed.
B. All the function buttons do not operate. C. Error symbol on the display.
16.IR sensor
17.AUX INPUT JACK
For information about using an AUX IN audio source, please see page 15.
18. USB PORT
For information about connecting a USB device, please see page 17.
19.TFT Display (liquid crystal display)
The operation of the TFT, please see page 16.