Bogen RM-350D manual Speaker Connections, Microphone ALC Automatic Level Control, AUX Input

1.Unplug the unit from electrical source.

2.Remove eight (8) screws securing the unit cover to the chassis.

3.Slide cover back to remove it from chassis.

4.Locate Jumper J1 on the circuit board (right side of the unit as you look at it from front panel).

5.Reposition jumper from CLOSED position to OPEN position.

6.Reinstall cover and screws.

Microphone ALC (Automatic Level Control)

An ALC switch on the rear panel controls the ALC circuit. When “ON,” the ALC will maintain a consistent level between vari- ous microphone users

AUX Input

Connect an Aux source to the RCA jacked marked AUX.

PREPAGE OUT

The prepage output lets you route tuner and auxiliary input to a telephone music-on-hold input. The output is also independent

of the tone and volume controls.

Speaker Connections

4-8ΩDirect Connection

You can connect a 4-8Ωspeaker to the terminals marked 4-8Ωand GND as shown below. Remove the LINK for 4-8Ωunbal-

anced output.

5