Basic operation
Listening to the tuner
1.Press the [FM• AM] button.
This will turn the tuner on.
To turn the tuner off, either press the [PWR] button or select another mode.
2.Tap the [FM• AM] button to switch to the desired FM or AM bands.
Each additional tap of the button switches the preset station sets from FM1 to FM2, FM3, then AM in sequence.
3.Press the [ 
] button to tune to a station.
A tap on either the [ 
] or [ 
] button for less than one button second will enable manual station tuning. Hold one button down for more than two seconds to start the automatic station search.
[ 
] button: Starts searching toward higher frequencies.
[ 
] button: Starts searching toward lower frequencies.
•If stations have been stored in memory, pressing a button from [1] to [6] will directly select a station. (Refer to the section “ Manually setting stations into memory” on page 33.)
20