Caution: Read this page carefully to ensure safe operation.
13.Lightning – For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the appliance due to lightning and
14.Abnormal smell – If an abnormal smell or smoke is detected, immediately turn the power OFF and unplug the appliance from the wall outlet. Contact your dealer or nearest service center.
15.Damage requiring service – The appliance should be serviced by qualified service personnel when:
A.The
B.Objects have fallen, or liquid has been spilled into the appliance.
C.The appliance has been exposed to rain or water.
D.The appliance does not appear to operate normally by following the instruction manual. Adjust only those controls that are covered by the instruction manual as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the appliance to its normal operation.
E.The appliance has been dropped, or the enclosure damaged.
F.The appliance exhibits a marked change in performance.
16.Servicing – The user should not attempt to service the appliance beyond that described in the instruction manual. All other servicing should be referred to qualified service personnel.
17.Outdoor antenna grounding – If an outside antenna is connected to the appliance, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. Article 810 of the National
Electrical Code ANSI/NFPA 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
| ANTENNA | |
| LEAD IN WIRE | |
GROUND CLAMPS |
| |
| ANTENNA | |
| DISCHARGE UNIT | |
| (NEC SECTION | |
ELECTRIC SERVICE | GROUNDING CONDUCTORS | |
EQUIPMENT | ||
(NEC SECTION | ||
| ||
| GROUND CLAMP | |
| POWER SERVICE GROUNDING | |
NEC – NATIONAL ELECTRICAL | ELECTRODE SYSTEM | |
(NEC ART 250, PART H) | ||
CODE | ||
|
18.Power lines – An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
19.AC outlets – Do not connect other audio equipment with a power consumption larger than that specified to the AC outlet on the rear panel. Never connect other electrical appliances, such as an iron or toaster, to it to prevent fire or electric shock.
20.Overloading – Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.
21.Attachment – Do not use attachments not recommended by the appliance manufacturer as they may cause hazards.
22.Replacement parts – When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock, or other hazards.
23.Safety check – Upon completion of any service or repairs to this appliance, ask the service technician to perform safety checks to determine that the appliance is in proper operationg condition.
24.Do not mount this appliance to a wall or ceiling. Refer to the installation section for proper placement.
ENGLISH
Notes:
1.Item 3 is not required except for grounded or polarized equipment.
2.Item 17 and 18 are not required except for units provided with antenna terminals.
3.Item 17 complies with UL in the U.S.A.
5