Gemini CDX-1210 Remote Control Section, Troubleshooting, Specifications, General, Audio Section

effect. To restart the song, press the PAUSE button.

22REVERSE: When the REVERSE button is pressed, the file that is currently playing begins to play in reverse mode.

23AUX INPUT (MP3): This 1/8” (3.5mm) input accepts any line-level source including MP3 players. Once a 1/8” (3.5mm) plug is inserted, the audio from the CD Player is cancelled out and only the AUX INPUT SOURCE will be heard out of the main outputs.

24VOLUME ROTARY KNOB: The VOLUME rotary knob ad- justs the volume of the LINE OUT output.

25SEARCH: The SEARCH buttons are used to fast-forward and rewind within a track.

REMOTE CONTROL SECTION:

26BPM: Press and hold BPM BUTTON to activate TAP tem- po. Once activated, tap the BPM BUTTON to display the tempo. Press and hold BPM BUTTON again to deactivate TAP tempo.

27DIRECT ACCESS BUTTONS: The direct access buttons allow you to inout a track number directly instead of hav- ing to skip through the tracks individually. Just press the number or combinations of numbers up to 99 and the payer will jump to that track after 3 seconds. Press the track number and press enter to go immediately to the new track.

28TRACK SKIP: The track skip buttons are used to skip to the next track or go back to the last track.

TROUBLESHOOTING:

-If a disc will not play, check to see if the disc was loaded correctly (label side up). Also check the disc for exces- sive dirt, scratches, etc.

-If the disc turns but there is no sound, check the cable connections, if they are ok, check your amplifier or re- ceiver.

-If the CD skips, check the CD for dirt or scratches. Do not assume that the CD player is defective. Many CD’s are recorded out of spec and will skip on most or all CD players. Before sending the unit for repair, try playing a CD that you are sure plays properly.

		CDX-1210
SPECIFICATIONS:
GENERAL:
Type		Compact Disc Player
Disc Type	Standard Compact discs (12 cm & 8 cm)
Time Display	Track Elapsed, Track Remain, or Total remain
Variable Pitch		± 16% Slider with Resume Switch
Pitch Bend		± 16% Maximum
Instant Start		Within 0.03 seconds
Installation		19” each
Dimensions		19” x 3.5” x 10” (482 x 89 x 255 mm)
Weight		5.51 lbs. (2.5 kg)
AUDIO SECTION:
Quantization		1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate		8 Times
Sampling Frequency		44.1 kHz
Frequency Response		20 Hz to 20 kHz
Total Harmonic Distortion		Less Than 0.05%
Signal to Noise Ratio		85 dB
Dynamic Range		85 dB
Channel Separatio		85 dB (1 KHz)
Output Level		2.0 +/- 0.2V R.M.S.
Power Supply		AC 115/230V, 60/50 Hz

S P E C I F I C A T I O N S A N D D E S I G N A R E S U B J E C T T O C H A N G E W I T H O U T N O T I C E F O R P U R P O S E O F I M - P R O V E M E N T .

6