XDA-1 Remote

The XDA-1 DAC preamplifier has a dedicated remote control that offers discrete buttons for most of the critical XDA-1 controls.

Power Buttons

ON Button

Discrete button to turn the XDA-1 on as indicated

STANDBY Button

Discrete button to put the XDA-1 in standby mode

Volume Controls

Applies continuous increase (UP) or decrease (DOWN) in volume levels while buttons are held down.

Input Selection Buttons

These discrete buttons select the various source inputs of the XDA-1. LED’s on the front panel of the XDA-1 will illuminate with the selected input

•AES/EBU - selects AES/EBU input as source

•OPT1 - selects OPT1 input as source

•OPT2 - selects OPT2 input as source

•CO.1 - selects CO.1 input as source

•CO.2 - selects CO.2 input as source

•USB - selects USB input as source

Dim Button

Varies the display intensity in 5 steps.

Mute Button

Mutes the sound when pressed. Press again to un-mute. The display window will show mute status

Changing the Battery

The XDA-1 remote is powered by 2 AAA batteries. To add fresh batteries, you must remove the 6 screws (use a no. 2 flat tip Phillips screwdriver), remove the aluminum back cover, exchange the batteries and orient the negative and positive ends as indicated by the images in the battery compartment. Emotiva recommends using alkaline batteries.

Note: In order to minimize the potential for damage to the screws holding the back cover, use only a number 2 Phillips screwdriver!