Panasonic CQ-CP134U Troubleshooting, Common, Disc Player, Error Display Messages, Radio

Page 15

Troubleshooting

If You Suspect Something Wrong

Check and take steps as described below.

If the described suggestions do not solve the problem, it is recom- mended to take the unit to your nearest authorized Panasonic Servicenter. The product should be serviced only by qualified person- nel. Please refer the checking and the repair to professionals. Panasonic shall not be liable for any accidents arising out of neglect of checking the unit or your own repair after your checking.

Never take measures especially for those other than indicated by italic letters in “Check point” described below because those are too dangerous for users to handle themselves.

Warning

¡Do not use the unit in an irregular condition, for example, with- out sound, or with smoke or a foul smell, which can cause ignition or electric shock. Immediately stop using the unit and consult your dealer.

¡Never try to repair the unit by yourself because it is dangerous to do so.

Trouble

Check point

Trouble

Check point

Common

No power

No sound

Noise

No sound from

left, right, front, or rear speaker

Left and right

sounds are

reversed

Start the engine. (Or turn the ignition switch to the ACC position.)

Verify the wiring. (battery lead, power lead, ground lead, etc.)

Fuse blown (Contact the nearest Panasonic Servicenter.)

Ask a professional for fuse replacement.

Be sure to use the same rated fuse.

Disable the mute function.

Verify the wiring.

Wait until the dew disappears before turning on the unit.

Make sure that grounding is established properly.

Adjust the balance and fader.

Verify the wiring.

Connect the speaker lead correctly.

Disc Player

No sound, or disc

Load the disc correctly.

is automatically

Clean the disc.

ejected

 

Sound skip,

 

 

 

 

 

 

poor sound

 

 

Clean the disc.

quality

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Sound skip

 

 

The maximum permissible tilt angle is

 

 

due to

 

 

30°.

vibration

 

 

Secure the unit.

 

 

 

 

 

 

 

 

 

 

Disc

 

 

Press [u]. If the disc is still not ejected,

 

 

 

 

contact the nearest Panasonic

unejectable

 

 

 

 

Servicenter.

 

 

 

 

 

 

 

Error Display Messages

(The disc is ejected automatically.) The disc is dirty, or is upside down. The disc has scratches.

Check the disc.

Radio

Frequent

noise

Preset data

deleted

Tune in to another station of high-inten- sity waves.

Make sure that the antenna mounted point is grounded properly.

The preset memory is cleared to return to the original factory setting when the power connector or battery is discon- nected.

No operation by some cause.

If normal operation is not restored, con- sult your dealer or the nearest Servicenter to ask for repairs.

Cannot read the file Check the file.

Image 15
Contents WMA MP3 CD Player/Receiver with CD Changer Control CQ-C1401UObserve the following warnings when installing Safety InformationPart 15 of the FCC Rules Observe the following cautions when installingBefore Reading These Instructions Maintenance / FuseAccessory Purchases Service in Puerto RicoPanasonic Auto Products Limited Warranty Limited WarrantyPress Disp Clock First Time Power On Clock SettingClock Display at Power Off PreparationOperations Radio AM/FM Frequency adjustmentPreset station selection APM Auto Preset MemoryRadio Source Display Station PresetAuto Preset Memory APM Manual station presetPause Player Disc PlayerTrack/file selection Folder selection MP3Player Source Display Random, Repeat, Scan Pen or other hard-point pens How to hold the discDisc cleaning Do not write on the disc label with a ballpointNo warranty On MP3Copyright Audio menu Audio SettingsDisc Player TroubleshootingError Display Messages CommonAM Radio SpecificationsGeneral FM Stereo Radio
Related manuals
Manual 16 pages 48.18 Kb