Realistic DX-440 warranty 001

Page 14

SPECIAL TUNING TECHNIQUES AND CONTROLS

In addition to the standard tuning oper- ations described previously, use the following controls for special operations.

RF GAIN CONTROL

This control adjusts the receiver'ssen- sitivity. For shortwave reception, rotate the control to the MAX position. This provides the maximum sensitivity. When you listen to the MW, standard AM band, or LW band, rotate the control only as far as needed to obtain a good signal. If you turn the knob further you might hear a distorted signal. For weak stations, rotate the control to the MAX position.

BFO PITCH

RF GAIN

If you encounter interference, adjust the control in both directions until you obtain the best compromise between your station and the interference.

BFO PITCH

RF GAIN

001

~SB USB MINMAX

AM NARROW!WIDE

SELECTIVITY SWITCH

Some stations transmit their signal so that very little space exists between their airspace and the station next to them on the band. If, while tuning, you encounter interference, caused by the signal from an adjacent station, press the button for the band you are listening to and select the NARROW position. The interference is reduced or muted.

,FM-,

MONO STEREO BFO LOCK

ciIiII:I.. .. .m..

WIDE NARROW OUT IN

OUT IN

LAM~'"

For full reception, leave the switch in the WIDE position.

r FM ,

MONO STEREO BFO LOCK

ciIiII:I. . .. .m..

WIDE NARROW OUT IN

OUT IN

.,. LAM-J

If you plan to listen to Morse code,refer- red to as CW (continuous wave), set the BFO switch to IN position. If you en- counter too much noise as you tune, set the AM NARROW/WIDE switch to NARROW position.

r- FM -,

MONO STEREO BFO LOCK

~.. . . . .

WIDE NARROW OUT IN

OUT IN

LAM-.J

USING HEADPHONES

While not a control, you might consider using headphones to obtain the best reception. Many stations broadcast marginal signals. Only headphones can capture the subtle difference between the signal from such stations and the surrounding noise often encountered at night. Be sure that the headphones terminate in a 1/8 inch plug, Insert the plug into the PHONES jack on the side of the radio. When you plug the head- phones in, you silence the speaker.

o

'fH~

OCIN9io

 

o

 

~

Because the radio can receive stereo FM, when you listen to FM stereo broadcasts, be sure your headphones are designed for stereo operation so that you can obtain the full benefit of this feature.

rFMi

MONO STEREO BFO LOCK

ciIiII:I.. . . .m..

WIDE NARROW OUT IN

OUT IN

LAM--.J

USING THE LOCK CONTROL

Use this switch to prevent unauthorized use of the radio or to ensure that any station you might be monitoring remains tuned in.

When you move the LOCK switch to the IN position, you disable the POWER button and the tuning controls. If the radio is on when you use the LOCK switch, you cannot turn off the radio or change the current frequency.

To release the LOCK function, set LOCK switch to out position

r FM,

BFO

LOCK "-

MONO STEREO

• •

 

 

 

 

WIDE NARROW OUT

IN

OUT

IN

LAM..J

26

27

Image 14
Contents Ownersmanual AM/FM Direct Entry Communications Receiver Contents IntroductionFeatures Control Locations 19. FM/MONO/STEREO/AMWIDEChoosing a Power Supply Installing BatieriesUsing Household AC Using AN Automotive BatierySelecting a Band and Turning on Power Preliminary SettingsSetting the Clock Tuning the Radio Band Frequency Antenna RangeODD OCJ 00000 Memory Tuning ILISetiing the Alarm Clock Radio OperationUsing the Sleep Timer L4=l001 DIBmJ 000 Using the Shoulder Strap Just the signal qualityAM Shortwave Bands Choosing AN AntennaFM Band System Grounding Band Allocation Shortwave Hobby Listening Notes Frequency Conversion FR3 Country LOGStation Location Remarks Cfcx11,910 BBC HcjbTroubleshooting Care and Maintenance AMLW,MW,SW LW/MWAM/FM Direct Entry Communications Receiver SSBRadio Shack AM/SSBIf AM/SSB/CW