Set Multisat Search 2, LNB No 2 and select horizontal TP from low band. Adjust skew (externally) to - value for maximum signal and quality.
Set Multisat Search 3, LNB No 3 and select vertical TP from high band. Adjust skew (externally) to + value for maximum signal and quality.
Set Multisat Search 4, LNB No 4 and select horizontal TP from high band. Adjust skew (externally) to - value for maximum signal and quality.
Finally press OK key on Start.
ADVANCE SEARCH: Special Feature
This feature is used when you want to search a satellite for any new channels or those not included in the Database or you do not have the full data of the channel. In INSTALL menu, go to Advance Search
NOTE: Searching with this feature is slower than normal search.
LNB No: Select number.
Satellite: Select satellite name.
Search Mode: Select search option. Option + D includes data channels ALL - All Video and Radio channels.
FTA - Free To Air Video and Radio channels ALL + D
Scan Freq: Select option. If you select All it will scan the complete frequency related to the LNB type you have selected. To define the frequency, select User Defined. This will allow you to enter the frequency on below menu lines.
Symbol Rate: Select option. If you select ALL it will scan with all Symbol Rates applicable. To define symbol rate, select User Defined and press OK. A sub menu will appear. Select and press OK on the symbol rates you wish to apply and finally EXIT.
Start Freq: Using
End Freq: Using
Polarity: select polarity.
Positioner: Select positioner if required. Configure this as described earlier.
Start: Press OK. TP search will start. Below Searching page will appear.
TUNING WIDEBAND LNB (in Advance Search)
NOTE: It is not possible to do index search in Advance Search and therefore each LNB No has to be tuned individually. Configure LNB as described earlier. Go to Advance Search and perform search for each LNB No that is pre adjusted for skew by external means.
Shows serial number of TP, Frequency, Symbol Rate (S/R), Polarity and FEC.
After the search for TP has finished, it will start channel search automatically and display the TV and Radio channels found.
TO CHANGE CHANNEL OR SATELLITE
There are two ways of changing channel or satellite as below.
TO SELECT A CHANNEL WITHIN THE SAME SATELLITE
Press OK key and browser will appear on your screen.
Use CH and PAGE up / down keys to scroll through the list. Press OK on required channel
TO SELECT A CHANNEL FROM ANOTHER SATELLITE Use VOL up / down to change the list.
Use CH and PAGE up / down to scroll through the list
Press OK on required channel. The antenna positioner will automatically move to that satellite. If you are using DiSEqC switch, then it will switch to that antenna.
SORTING THE CHANNEL LIST
Press Green key to sort channels alphabetically.
Press Yellow key to sort channels Free To Air first followed by Scrambled.
Press Red key to return to normal list.
9