Example To configure four LNB | Manhattan Computer Products ST100

EXAMPLE: To configure four LNB

Astra 2 (28.2E), select LNB No 1 and set DiSEqC to 1 Astra 1 (19.2E), select LNB No 2 and set DiSEqC to 2 Hotbird 1-6 (13E), select LNB No 3 and set DiSEqC to 3 Thor 2, 3 (1W), select LNB No 4 and set DiSEqC to 4

EXAMPLE: To configure MONOBLOCK LNB

Astra 1(19.2E), select LNB No 1 and set DiSEqC to Mini-AHotbird 1-6(13E), select LNB No 2 and set DiSEqC to Mini-B

CONFIGURING WIDEBAND LNB

Set LNB No 1 to 14V Skew On (for Low Band Vertical polarity)

Set LNB No 2 to 14V Skew On (for Low Band Horizontal polarity)

Set LNB No 3 to 18V Skew On (for High Band Vertical polarity)

Set LNB No 4 to 18V Skew On (for High Band Horizontal polarity)

NOTE: This receiver does not provide Mechanical Polarizer Output Connectors. Therfore for tuning Wideband LNB you need to provide external means of adjusting skew on the LNB.

12V: To select 12 volts output for relay type LNB switch.

STORE: After above settings move to store and press OK key

DiSEqC 1.2 menu (Manual positioner)

With DiSEqC 1.2 antenna positioner, you can search and download individual satellites with manual positioning.

In Channel Search menu go to Positioner and select DiSEqC 1.2 and press OK key. A sub menu will appear.

Move: Move antenna furthest possible East or West and enter the limits below.

East Limit: After furthest East enter the limit here

West Limit: After furthest West enter the limit here

Erase Limits: To clear limits press OK

0 Position: To move to 0 position on motor.

LOCATING PRE-STORED SATELLITES

Re-sync:

First find one of the listed satellites manually by obtaining maximum signal and quality. Then select Re-sync and press OK key. All other listed satellites can now be found automatically during channel search.

STORE: After above settings move to store and press OK key

DiSEqC USALS menu (Automatic positioner)

You can search and download up to 40 satellites at a time automatically using the DiSEqC USALS menu.

In channel search menu go to Positioner and select DiSEqC USALS and press OK key. A sub menu will appear.

Longitude: Enter your location using 0-9 keys and then PAGE up / down keys to enter E (East) or W (West).

Latitude: Enter your location using 0-9 keys and then PAGE up / down keys to

enter N (North) or S (South). EXAMPLE: London – Longitude = 0 and Latitude = 51.5N

USALS: Press OK to move antenna automatically to required satellite.

0 Position: To move to 0 position on motor

STORE: After above settings move to store and press OK key

CHANNEL SEARCH -- Automatic Scan and Search

Using DiSEqC USALS menu you can search and download up to 40 satellites automatically at a time. Follow settings below.

Multisat Search: Set index numbers for each satellite you wish to search.

LNB No: If you are using more than one LNB, select LNB No as configured previously. If you are using one LNB then this may remain as 1.

Satellite: Press OK and select satellite name. Remember that you have to select a different name for each index number.