Metra Electronics 99-7878B Double DIN/STACKED ISO Mount Units Radio Provision

99-7878B KIT ASSEMBLY

DOUBLE DIN/STACKED ISO MOUNT

UNITS RADIO PROVISION

*Note: Refer also to the instructions included with the aftermarket radio.

A

1Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation.

2Cut and remove the center bar from the radio housing. (Figure A)

3Snap the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure B)

4Slide the Double DIN head unit or stacked ISO head units into the bracket/radio housing assembly and secure the Double DIN head unit or stacked ISO head units to the assembly using the screws supplied with the radio. (Figure C)

5Snap the Double DIN trim plate into the Radio Housing. (Figure C)

6Reassemble dash in reverse order of disassembly.

B

C

1-800-221-0932 www.metraonline.com

REV. 07/15/09 © COPYRIGHT 2009 METRA ELECTRONICS CORPORATION INST99-7878B