NEC LCD1770GX user manual Quick Start, English-4

Quick Start

To attach the MultiSync LCD monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws.

For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure B.1). Tighten all screws.

DVI signal cable	Figure A.1	Figure A.2
(not included)

Macintosh

Cable Adapter Figure B.1 (not included)

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

3.Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position (Figure C.1).

4.Connect all cables to the appropriate connectors (Figure C.1).

NOTE: If connecting both DVI and D-sub cable, the DVI cable must be connected along side the rib on the power cord side (Figure C.1).

5.For successful cable management, place the cables in this order into the cable management: Power cable, DVI cable, D-Sub cable and USB cable (Figure C.2).

30˚ Tilt

DVI Cable (Top)

D-Sub Cable

Highest
Stand
Position		USB Cable
		Power Cable (Bottom)
	DVI Cable	Input2 (D-Sub)
		USB
	Input1 (DVI)
Power cord	Figure C.1	Figure C.2
	DC-OUT
	NEC optional product attachment.
	Do not use this connector unless specified.

English-4