Xantech installation instructions RF2IR Diagram Front, Quick Start Instructions

Page 3

RF2IR Diagram (Front)

IR LED, RF LED: Flashes when emitting IR and RS232 commands

Quick Start Instructions

Step 1. Plug the (4) 283M emitters (included) into the port labeled IR output 1 thru 4 on the back of the RF2IR. Next, place the associated 283M emitter head directly over the IR eye on the proper source component to be controlled.

Step 2. Plug the RS232 Adapter Cable (if required) into the RF2IR port labeled RS232. Next, connect the DB9 plug to the source component to be controlled. In some instances, a null modem converter may be required. Below is a pin-out of the RS232 Adapter Cable.

Step 3. Plug the power supply into the RF2IR port labeled 12VDC. The IR and RF LEDs will illuminate for 10 seconds. This is part of the start-up sequence. After the LEDs turn ‘off’, the RF2IR is ready to be used.

Step 4. Follow the XTR39 Instructions, RF2IR Addendum and follow the steps to setup the XTR39.

- 3 -

Image 3
Contents RF2IR Specifications RF2IR Diagram RearWelcome Quick Start Instructions RF2IR Diagram FrontLocating the RF2IR Care and MaintenanceXantech Limited Warranty