Xantech installation instructions Locating the RF2IR, Care and Maintenance

Page 4

RF2IR Configuration (Channel Address)

The Channel Address on the RF2IR cannot be programmed using Universal Dragon. Located on the bottom of the RF2IR device is a rotary switch. Turn this switch to select the desired Channel Address. The switch is labeled in HEX notation. “A” stands for Channel Address “10”. “B” stands for Channel Address “11”. The Channel Address increments with the alphabet until it ends at “F”, which is “15”.

Locating the RF2IR

Thanks to Xantech’s superior antenna design, the RF2IR can be placed in several locations.

Key Location Points:

The RF2IR should be placed on a flat, stable surface.

For optimal performance, the RF2IR should be placed at a height greater than 3 feet above the floor. The ideal height should be level to the XTR39 transmitter.

Avoid placing the RF2IR near corners of a room.

Avoid placing the RF2IR next to microwave ovens.

Care and Maintenance

Clean the outside of the plastic housing using a soft cloth. Use warm water and mild soap solution. Do not use abrasive cleaners.

Information

FCC NOTICE

* Section 15.19 Labeling requirements

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference and

(2)This device must accept any interference received, including interference that may cause

undesired operation.

* Section 15.21 Information to user

The changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

*IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.

0197

RF2IR RF Base Station Quick Start Installation Instructions

© 2006 Xantech Corporation

This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from Xantech Corporation.

Xantech Corporation shall not be liable for operational, technical, or

editorial errors/omissions made in this document.

Document Number 08905083A

- 4 -

Image 4
Contents RF2IR RF2IR Diagram Rear SpecificationsWelcome RF2IR Diagram Front Quick Start InstructionsCare and Maintenance Locating the RF2IRXantech Limited Warranty