OPERATING INSTRUCTIONS
NORMAL OPERATION
RECEIVE OPERATING PROCEDURE
1.Connect the 13.8 Volt power lead, microphone and antenna.
2.Select the NORMAL mode by selecting the SCAN switch (3) to the 'OUT'position.
3.Rotate the SQUELCH control (15) fully counterclockwise.
4.Switch the radio on by turning the OFF/VOLUME control (14) clockwise and adjust for a comfortable volume level, and adjust for a comfortable squelch level.
5.Rotate the CHANNEL SELECTOR switch (20) to select the required channel.
TRANSMITTING
To transmit, depress the PRESS- TO- TALK switch (1) on the microphone. Hold the micro- phone
PROGRAMMING SCAN CHANNELS
When the radio is initially powered up, there will not be any channels programmed into the Group Scan Memory.
To program scan channels into the Group Scan memory, use the following procedure:
1.Select the NORMAL mode by selecting the SCAN switch (3) to the 'OUT'position.
2.Select the GROUP SCAN Mode by selecting the OS/GS Select switch (4) to the 'OUT' position. The GS indicator (9) should be lit.
3.Rotate the CHANNEL SELECTOR switch (20) until the channel you wish to scan is dis- played. Note that the MEM indicator (10) should NOT be lit, indicating that this channel is not currently programmed into the GROUP SCAN memory.
4.Press and hold the MEM switch (16) for about 1 second until a BE.EP is heard. The MEM indicator (10) should now be lit indicating that the channel is now programmed in- to the memory.
5.Continue steps 3 and 4 to program all the channels you wish to scan.
Select |
| Select | Select | Install | 'MEM'Light | |||
NORMAL |
| GROUP SCAN | CHANNEL | CHANNEL |
| ON |
| |
SCAN |
| OS | unlden | MEM |
|
|
| ,- |
|
|
|
|
| ||||
[DJ | + | r;u: |
| DJ | 1~,1I | |||
|
|
| l } t | - |
| I | ||
| ~ '°;1+ | ~' |
| I LI | ||||
| - BEEP! . |
|
|
|
| |||