Loading a disc
Press P.ANGLE/EJECT button on the panel to flip it down. Insert the disc with the printed side facing upward into the slot. Close the panel. The disc will be loaded and played automatically. If the unit is in another mode, press DVD screen button, POWER/SRC button on the unit or MODE button on the RC repeatedly to select DVD mode.
Press and hold P.ANGLE/EJECT button on the panel to eject the disc.
Inserting a SD/MMC card/USB device
Insert the MMC/SD card into the corresponding slot on the top of the panel and insert USB device into the USB jack on the panel. The unit will automatically switch to the needed mode.
The unit cannot operate MMC/SD card and USB device at the same time. Before inserting a memory card you should first remove the USB from the unit, and vice versa.
Note: Some USB driver models cannot be supported by this unit.
Playing/pausing
When the disc/card/USB has been loaded, the playback of the first track starts automatically. To ensure good system performance, wait until the unit finishes reading the disc information before proceeding.
Press PLAY/PAUSE button on the RC or PLAY/PAUSE/AST button on the unit to start playback. Press it again to pause the playback. Press again to resume the playback.
Stop playback
During playback, press STOP/RETURN button on the RC. Playback will be stopped.
For DVD discs: If PLAY/PAUSE button on the RC or PLAY/PAUSE/AST button on the unit is pressed, playback will start from the position at which it was stopped. If the disc is removed, the resume function is cancelled. Press STOP/RETURN button on the RC twice to finally stop the playback.
22