Panasonic CQ-VD7005U warranty Time Alignment, Source Level, Center ting, AV1 Level, AV2 Level

Note:

¡While the private mode is active, only

FRONT L and

FRONT R can be

adjusted.

TEST TONE (Test tone output)

ON : enables the test tone.

OFF : disables the test tone.

default: OFF

¡When the test tone is set to on, test signal (a continu- ous tone) is output from each speaker for approximately 2 seconds.

Adjust the output balance so that the tone appears to have the same volume from each speaker.

Adjusting the output balance:

Adjust the volume of all of the other speakers to the vol- ume level of the speaker from which the test signal appears to be the quietest.

TIME ALIGNMENT

Adjusting the timing with which the audio from each speaker reaches the listener’s position

(Center speaker delay time set-

CENTER ting)

]	: down,	[	: up
		Setting range: 0 ms to 5 ms (1 ms steps)
				1 ms = 0.001 seconds
				default: 0 ms
				(Surround speaker delay time
	SUR
				setting)
]	: down,	[	: up
		Setting range: 0 ms to 15 ms (1 ms steps)

1 ms = 0.001 seconds default: 0 ms

¡Make this adjustment while listening to sound. ¡If the speaker setting is NONE for a speaker, that

speaker cannot be selected.

¡When “PRO LOGIC” is displayed, 15 ms are automatically added to the delay time setting for the surround speakers.

English

SOURCE LEVEL

36

Setting the AV1/AV2 input level

Make this setting if it is not possible to adjust the volume through the connected device (on the output side).

AV1 LEVEL		(Setting for AV1)
	: sets the level low/sound volume increases.
LOW
	: sets the level high/sound volume decreases.
HIGH
		default:
			HIGH
AV2 LEVEL		(Setting for AV2)
	: sets the level low/sound volume increases.
LOW
	: sets the level high/sound volume decreases.
HIGH

Note:

¡If the input level from AV1/AV2 is too high, the audio will not be output normally.

¡After setting the input level

The volume can be adjusted by pressing [+] or [–] (VOL) on the remote control or turning rotary volume controller on the unit.

					default:	HIGH
CROSS OVER
Cut off frequency
LPF CUT OFF					(Sub-woofer Low Pass Filter)
]	: down,	[	: up
					Setting range: 63 Hz to 200 Hz
					default: 125 Hz
HPF CUT OFF					(High Pass Filter)
]	: down,	[	: up
				Setting range: off, 63 Hz to 200 Hz
					default: off

Note:

¡This setting is not available if CS Auto is set to ON .

¡HPF CUT OFF is enabled only on the front speakers (R/L) and rear speakers (L/R).

CQ-VD7005U

37