Clarion DXZ535 owner manual Case of Difficulty, TV Operations Auto store Setting the TV area

TV Operations

Auto store Setting the TV area

9. IN CASE OF DIFFICULTY

English

Auto store selects 6 TV stations automatically and stores each one into preset memory.

If there are not 6 stations with good reception, stations previously stored in memory remain and only the strong stations are stored into memory.

1.Press the [BND] button and select the de- sired TV band (TV1 or TV2).

2.Press and hold the [P/A] button for 2 sec- onds or longer. The stations with good recep- tion are stored automatically to the preset channels.

Preset scan

Preset scan allows the user to view each preset position before it automatically advances to the next preset. This function is useful for searching for a desired TV station in memory.

1.Press the [P/A] button.

2.When the desired station is found, press the [P/A] button again to remain tuned to that station.

When you select the TV area (TV reception area), the TV tuner area setting changes.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “TV AREA”.

3.Press the [ ] button.

4.Turn the [ROTARY] knob clockwise or coun- terclockwise to select the reception area.

5.Press the [ ] button.

6.Press the [T] button to return to the previous mode.

The above operations are required when a TV tuner other than TTX7501z is connected.

	Problem	Cause	Measure
	Power does not turn	Fuse is blown.	Replace with a fuse of the same amperage. If
	on.		the fuse blows again, consult your store of
	(No sound is pro-		purchase.
	duced.)
		Incorrect wiring.	Consult your store of purchase.
	No sound output	Power antenna lead is shor-	1. Turn the unit off.
	when operating the	ted to ground or excessive	2. Remove all wires attached to the power
	unit with amplifiers or	current is required for re-	antenna lead. Check each wire for a possible
	power antenna at-	mote-on the amplifiers or	short to ground using an ohm meter.
	tached.	power antenna.	3. Turn the unit back on.
			4. Reconnect each amplifier remote wire to the
General			power antenna lead one by one. If the
			amplifiers turn off before all wires are
			attached, use an external relay to provide
			remote-on voltage (excessive current
			required).
	Nothing happens	The microprocessor has	Turn off the power, then
	when buttons are	malfunctioned due to noise,	press the [OPEN] button	Reset button
	pressed.	etc.	and remove the DCP.
			Press the reset button for
	Display is not accu-		about 2 seconds with a
	rate.		thin rod.

English

Note:

•Do not press and hold the [P/A] button for 2 sec- onds or longer. Doing so will trigger the auto store function and start storing stations into memory.

Setting the TV diver

You can change the reception setting for the TV antenna connected to the TV tuner.

1.Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display.

2.Press the [a] or [d] button to select “TV DIVER”.

3.Turn the [ROTARY] knob clockwise to set to “ON” or counterclockwise to set to “OFF”.

●ON:

Sets reception emphasizing the visual.

●OFF:

Sets the diver setting to OFF.

4.Press the [T] button to return to the previous mode.

		DCP or main unit connec-	Wipe the dirt off with a soft cloth moistened with
		tors are dirty.	cleaning alcohol.
	Compact disc cannot	Another compact disc is al-	Eject the compact disc before loading the new
	be loaded.	ready loaded.	one.
	Sound skips or is noi-	Compact disc is dirty.	Clean the compact disc with a soft cloth.
	sy.
		Compact disc is heavily	Replace with a compact disc with no scratches.
CD		scratched or warped.
	Sound is bad directly	Water droplets may form on	Let dry for about 1 hour with the power on.
	after power is turned	the internal lens when the
	on.	car is parked in a humid
		place.

24 DXZ535 DXZ535 25