Adjusting the Treble
This adjustment can be performed when the Z- enhancer Plus is set to “CUSTOM”.
1)Press A button % and select “TREB”.
2)Turning Rotary knob $ clockwise empha- sizes the treble; turning it counterclockwise attenuates the treble.
*The factory default setting is “0”. (Adjustment range:
3)When the adjustment is complete, press A button % several times until the function mode is reached.
Adjusting the Balance
1)Press A button % and select “BAL”.
2)Turning the Rotary knob $ clockwise empha- sizes the sound from the right speaker; turn- ing it counterclockwise emphasizes the sound from the left speaker.
*The factory default setting is “0”. (Adjustment range: L13 to R13)
3)When the adjustment is complete, press A button % several times until the function mode is reached.
Adjusting the Fader
1)Press A button % and select “FAD”.
2)Turning the Rotary knob $ clockwise empha- sizes the sound from the front speakers; turn- ing it counterclockwise emphasizes the sound from the rear speakers.
*The factory default setting is “0”. (Adjustment range: F12 to R12)
3)When the adjustment is complete, press A button % several times until the function mode is reached.
Loudness Effect
In order to turn on/off the loudness effect, use the LD button % for 1 second or longer. Every time the LD button % is pressed and held for 1 second or longer, the loudness effect switches on and off.
*When the loudness effect is on, the display will show “LD”.
Switching the Clock Display
Every time the DISP button 7 is pressed, the display will change between the operation mode and the clock display.
Setting the Clock
1)Press the DISP button 7 to display the clock display.
2)Press and hold the DISP button 7 for 1 sec- ond or longer.
3)Press the SRCH Left button 2, then set the current hour.
4)Press the SRCH Right button 2, then set the current minute.
5)Press the DISP button 7, then the clock is set.
Notes:
•If you select another operation mode while you are setting the clock, the clock setting operation will be canceled.
•If you remove the vehicle’s battery for a check or repair, the clock will be reset, so you must set it again.
Turning the screen saver function on or off
This unit is equipped with the function which enables you to display a variety of patterns and characters in the Operation status indication 2 in a random order. You can turn this function on or off.
*The factory default setting is on.
While pressing the Disp button 7, press the SS button ! to switch the function.
*The following illustration shows one of the patterns displayed when the screen saver function is set to on.
English
DB325 11