,
?
| Problem | Causes / Actions |
| |
|
| ●Check the LAN cable or wireless LAN is connected properly. | (p. 46) | |
|
| ●Check the connections and settings. | (p. 47 - 49) |
|
|
| ●Check the network equipment and network environment. |
| |
| Cannot connect to the | ●The router may not be set to issue IP address automatically. If the network | ||
| network | administrator prefers to allocate an IP address, set an IP address manually. | ||
Network |
| (p. 47 - 49) |
|
|
| ●If the problem persists, consult your Internet Service Provider or | |||
|
| |||
|
| telecommunications company. |
|
|
|
|
|
| |
| Cannot select the file | ●Is the media server of the connected equipment prepared? | (p. 45) | |
| during DLNA operations | ●Check applicable data format. (p. 68) |
| |
|
|
|
|
|
| Cannot access the Internet | ●Check the connections and settings. | (p. 47 - 49) |
|
| contents | ●The server or connection line might be busy now. |
| |
|
|
| ||
| The TV does not switch on | ●Check the mains lead is plugged into the TV and the socket outlet. | ||
|
|
|
| |
| The TV goes into Standby | ●Auto power standby function is activated. (p. 10) |
| |
| mode | ●The TV enters Standby mode about 30 minutes after broadcasting ends. | ||
|
|
|
|
|
|
| ●Are the batteries installed correctly? | (p. 7) |
|
|
| ●Has the TV been switched on? |
|
|
| The remote control does | ●The batteries may be running low. Replace them. |
| |
| ●Point the remote control directly at the front of the TV (within about 7 m and a | |||
| not work or is intermittent | |||
| 30 degree angle of the front of the TV). |
|
| |
|
|
|
| |
|
| ●Situate the TV away from sunshine or other sources of bright light not to shine | ||
|
| on the TV’s remote control signal receiver. |
| |
|
|
| ||
Other | Parts of the TV become | ●Even when the temperature of parts of the front, top and rear panels has risen, | ||
or quality. |
|
| ||
hot |
|
| ||
|
| these temperature rises do not cause any problems in terms of performance | ||
|
|
|
|
|
| The LCD panel moves | ●There is some flexibility around the panel to prevent damage to the panel. | ||
| slightly when it is pushed | |||
| with a finger | ●The panel might move slightly when it is pushed with a finger, and clattered | ||
| Clattered sound might be | sound might be heard. This is not a malfunction. |
| |
| heard |
|
|
|
|
|
| ||
| Overcurrent error | ●The connected USB device might cause this error. Remove the device and | ||
| turn the TV off with Mains power On / Off switch, then turn it on again. | |||
| message appears | |||
| ●Check foreign objects are not inside the USB port. |
| ||
|
|
| ||
|
|
|
|
|
|
| ●Follow the message’s instructions. |
|
|
| An error message appears | ●If the problem persists, contact your local Panasonic dealer or the authorised | ||
|
| service centre. |
|
|
|
|
|
|
|
FAQs
73
2/16/2012 5:22:11 PM