Page 6 of 15 | SA-430-17 Installation and Operating Instructions |
OPTION SWITCHES
An 8-position DIP switch on the remote amplifier may be changed to select various options.
Option Switches
On Remote Amp
ON
Option Switches
Default Setting (Shown) all OFF (UP)
SW-1Two-Tone- Turn this switch on to replace Phaser tone with Two-Tone.
SW-2 Mechanical Override - Pressing the Siren push-button normally produces Horn tone while the rotary function switch is in Mechanical. Turn this switch on to manually override Mechanical tone instead.
| SW-3 | | SW-4 | | Siren push-button and Auxiliary Input Function | |
| | | | | with Rotary Selector Switch in Standby | |
| OFF | | OFF | | (Default) Produces Horn tone while pressed. | |
| ON | | OFF | | Manual control of Mechanical tone. | |
| | | | | Also Mechanical tone continues to fall when Rotary | |
| | | | | Selector Switch is changed from Mechanical position. | |
| OFF | | ON | | Manual control of Wail tone. | |
| ON | | ON | | Activates Horn Ring Cycler 2 (HRC2) function. | |
SW-6 and | SW-7 | Cutout Input Polarity - The cutout input is normally activated by |
connecting to positive. To activate by connecting to negative turn SW-6 and SW-7 on.
SW-5 and SW-8 - Not Used… Leave Off.
Horn Ring Cycler 2 (HRC2) - Turn on DIP SW-3 and SW-4 to enable this feature. Also connect the auxiliary input to the horn ring or other switch. While the siren is in standby, tap the horn ring to bring the unit out of standby into Mechanical tone. Repeatedly tapping the horn ring will cycle through Mechanical, Wail, Yelp, and Phaser tones. Tapping the horn ring twice quickly will stop the siren tones and return the unit to standby. Pressing and holding the horn ring will produce Horn tone until released. Then the siren will return to its previous siren tone or standby.
