Arcam Comprehensive Guide to AVP 700 Pre-Amplifier and Processor

Page 1

HANDBOOK/MANUEL/HANDBUCH/HANDLEIDINGAVP700

Arcam AVP700 Pre-amp. processor	English

Préamplificateur-processor Arcam AVP700	Français

Vorverstärker/Prozessor Arcam AVP700	Deutsch

Arcam AVP700 Voorversterker processor	Nederlands

Image 1

Contents Arcam AVP700 Pre-amp. processor Important safety instructions Safety guidelinesSafety compliance Contents Inserting the batteries into the remote control Using this handbookBefore you start IntroductionZone 2 explained Before making connectionsAudio VideoPositioning the unit InstallationAVP700 rear panel CablesAnalogue audio connections Audio connectionsAnalogue pre-amplifier outputs Connection of record decksComposite/S-video video connections Video connectionsComponent video connections Important notes about HQ-video inputs and outputsZone 2 connections Scart RGB 4-WIRE ConnectionConnecting to a power supply Connecting the AM and FM antennasControl connections Set-up mode Configuring the AVP700Set-up Menu Index Navigating the Set-up menu‘Basic’ Set-up Menus General SettingsSelect Cvbs status Speaker Sizes Sub woofer SettingsSurr L/R Small Large Speaker delay settings Speaker Delay SettingsDistance measurements for 5.1 EX Settings Level settingsADV 3 Digital Settings ADV 2 Video Settings‘Advanced’ Set-up Menus ADV 1 Speaker EqADV 4 Zone 2 Settings Saving Settings and Exit Set-upADV 5 Analogue Settings ADV 6 Hdmi SettingsRemote control Volume control Switching on/offOperating your AVP700 Front panel displayInput selection HeadphonesStereo Direct ZoneEffects/FX Remote control buttonsMode Treble/BassUsing the tuner Using the remote control to enter the Main Menu Using the Main MenuUsing the front panel to enter the Main Menu Listening to the tuner in ZoneEffect Display Centre spreadingDigital multi-channel sources Surround modesMulti-channel source modes Two-channel source modesFollowing decoding and surround modes are available Mono DSP Effects Modes Speaker positioningTroubleshooting No Zone 2 audio when playing DTS film Source switching changes randomly or freezes on one sourceUnable to adjust bass and treble controls Sound is poor or distortedIR Remote Codes Command Command codeSystem code Command Command code Scart RGB cable with audio back to processor Scart connectionsScart S-video cable with audio back to processor Continual improvement policy Technical specificationsRadio interference Worldwide Guarantee GuaranteeOn line registration

Related manuals

Manual 43 pages 3.92 Kb