Installation
Due to the high power output of the MRV-F900, considerable heat is produced when the amplifier is in operation. For this reason, the amplifier should be mounted in a location which will allow for free circulation of air, such as inside the trunk. For alternate installation locations, please contact your authorized Alpine dealer.
1.Using the amplifier as a template, mark the four screw locations.
2.Make sure there are no objects behind the surface that may become damaged during drilling.
3.Drill the screw holes.
4.Position the MRV-F900 over the screw holes, and secure with four self-tapping screws.
NOTE:
To securely connect the ground lead, use an already installed screw on the metal part of the vehicle (marked (★)). Be sure this is a good ground by checking continuity to the battery (–) terminal. As much as possible connect all equipment to the same ground point. These proce- dures will help eliminate noise.
1Self-Tapping Screws (M4 x 20)
2 Ground Lead
3 Chassis
4 Holes
1
2
★
3
Fig. 1
4
