Atlona AT-PA100-G2 user manual Specifications, Audio

Command	Feedback	Description
8xx%	Bass of LINE: xx	Preset the bass level, [xx] arranges from [00] to [08].
		Example: 803%	--> Bass of LINE: 03
9xx%	Treble of LINE: xx	Preset the treble level, [xx] arranges from [00] to [08].
		Example: 905%	--> Treble of LINE: 05

Do not use a carriage return at the end of the commands. “.” and “%” terminate the commands.

Note: Factory Default settings, when first turned on, are: volume 50, bass 4, and treble 4.

Note: The AT-PA100-G2 has last memory, so if the power is lost the volume, bass, and treble settings will remain the same as before the power loss.

Specifications

Input Ports	2 x RCA connectors
	1 x 3.5mm Audio
	1 x 3.5mm IR
	1 x Captive Screw MIC
	1 x Captive Screw RS-232
Output Ports	1 x Captive Screw Audio
	1 x 3.5mm Loop Out
Dimensions (HxWxD)	1.5 x 3.78 x 3.43 (inch)	38 x 96 x 87 (mm)
Weight	0.66lbs	0.3kg
Power consumption	40W
Audio
Gain:	32dB
Frequency Range:	20Hz to 20KHz
Signal/Noise Ratio:	80dB (at max output)
Total Harmonic Distortion:	1% (1KHz), 0.3% (20KHz) -- at nominal levels
Input Impedance:	Input 1&2: >10KΩ
MIC Input Impedance:	48V: 35KΩ
	MIC: 10KΩ
	LINE: 75KΩ
Output Impedance:	3.5mm Loop Out: 50Ω stereo
	Speaker out: 4 ~ 8Ω Amplifier
Stereo Channel Separation:	>75dB from 20Hz to 20KHz
Common Mode Rejection Ratio:	>70dB from 20Hz to 20KHz
MIC Audio Detection Delay:	1ms

atlona.com	9	Toll free: 1-877-536-3976
		Local: 1-408-962-0515