Atlona AT-PA100-G2 user manual Panel Description, Back Panel

Panel Description

Front Panel

	1	2	3
	MONO			RS-232
STEREO		BRIDGE		TX	RX
		IR	CONTROL
+	-	MIC
	48V	LINE
	MIC	L	R	3.5mm
		INPUTS
	4	5	6		7

1.Audio output format switch: Use to switch between Stereo, Dual Channel Mono, and Bridged audio outputs

2.3.5mm IR: Connect optional IR receiver here for use with optional IR remote (AT-PA1-IR)

3.Captive Screw RS-232: Connect RS-232 here for control

4.Captive Screw Input: Connect a MIC

5.Audio input switch: Switch between 48V Phantom powered condenser MIC, Dynamic MIC, or LINE

6.L/R audio: Connect Analog audio into this port

7.3.5mm audio: Connect Analog audio into this port

Back Panel

	1x40Watt@8	+	-
	2x20Watt@4	+	- - +
24V	LOOP

1

OUTPUTS

2 3

1.Locking 24V Port: Connect included locking power supply here.

2.3.5mm variable audio loop out: Loop out to another AT-PA100-G2 or audio amplifier with a 3.5mm stereo audio connector

3.Captive Screw Audio: Connect to speakers

Note: In a cascading chain, the AT-PA100-G2s will share the source of the 1st AT-PA100-G2.

Note: When using the loop out, the output is variable and dependant on the volume level. If cascading, the 2nd AT-PA100-G2’s volume will change with the 1st AT-PA100-G2.

Note: The volume status is available through RS-232 feedback from the first AT-PA100-G2.

Note: When cascading, the MIC is only available for the first AT-PA100-G2’s speaker output.

atlona.com	4	Toll free: 1-877-536-3976
		Local: 1-408-962-0515