Congratulations on your Purchase

Your new high fidelity bridgeable/stereo amplifier is designed to deliver maximum enjoy ment and one year of trouble free service. Please take a few moments to read this manual thoroughly. It will explain the features and operation of your unit and help insure trouble free installation.

Features

•Four Class ''AB'' High-Current Dual Discrete Drive Stages.

•Class ''AB'' Technology MOSFET PWM Power Supply.

•Bridgeable & TRI-Mode Operation.

•Continuously Variable 12dB/Octave High Pass & 12dB /Octave Low Pass Crossover.

•Subwoofer Variable Crossover for Deep Bass Control.

•Enhanced Bass Boost +12dB @ 45Hz.

•Silver Plated RCA, Power & Speaker Terminal.

•Soft Start & Muting.

•Overload, Thermal and Short Circuit Protection.

•Power & Protection indicator.

•Bass Level Remote Control(16.4Fit) - T-1000M / T-2130

Precautions: Read First!

•If after reading the directions you feel uncomfortable about installing the amplifier in your car, or not equipped or competent to do so, you should have the amplifier installed by an authorized installer. It's your car!

•Negative battery terminal must be disconnected before any electrical connections are made.

•Be sure choose a location that provides substantial ventilation for the amplifier. The most preferred locations would be in your car's trunk, under the front seats or on the back wall of a truck.

•The location chosen should provide at least 2" of clearance above the amplifier for adequate ventilation.

•If the amplifier is to be mounted vertically be sure that it is in a place where adequate air will flow along the length of its heatsink fins for cooling.

•NEVER mount the amplifier up side down, this will cause the heat to rise back into the amplifier causing thermal shutdown or possible permanent damage.

•NEVER mount the amplifier in a location that is subject to direct sunlight or exposed to moisture.

•Be sure to mount the amplifier to a strong, solid surface which will not give way under the stress of a sudden stop or accident.

•Make sure that the mounting screws will not penetrate the gas tank, brake and fuel lines, wiring or other critical parts of your car when installed.